After buying the toilet seat, we can install it at home. The toilet seat is generally divided into an upper lock type and a lower lock type. You must first see it clearly before installing it.
Tools: 1 Phillips screwdriver.
(1) Locking installation.
1: Take out the toilet lid and fixed accessories, and confirm that the locking accessories are complete.
(Accessories: 1 pair of expansion bolts, 1 pair of plastic supports, 1 pair of screws, 1 pair of decorative covers)
2: Put the small end of the white expansion bolt down and install it into the ceramic mounting hole;
3 Align the plastic support with the ceramic mounting hole;
4: Install the screws, tighten the screws to 9 minutes, so that the support can be slightly loosened, so as to try to install the cover;
5: Align the two small holes of the cover plate with the support column and insert it vertically, adjust the cover plate front, back, left, and right to make it match the toilet, and then fully tighten the screw until the fixed support cannot be moved;
6: Open the cover, press the button on the front of the cover, remove the cover vertically, and then install the stainless steel decorative cover on the support.
7: Install the cover again, check whether the slow-down function of the cover is normal, and the installation is complete.
(2) Bottom lock installation.
1: Take out the toilet lid and fixed parts, and confirm that the lock parts are complete.
(Accessories: 1 pair of plastic supports, 1 pair of screws, a pair of lower lock washers, a pair of lower lock bolts, and a pair of decorative covers);
2: Put the screw into the plastic support and place it on the toilet installation hole;
3: Put the washer on the plastic nut, hold the top of the screw with one hand, and screw the nut to the screw from the bottom of the toilet to 9 minutes tightly, so that the support can be slightly loosened, and the screw is longer. The same is true on the right;
4: Align the two small holes of the cover plate with the support column and insert it vertically, adjust the cover plate front, back, left, and right to make it match the toilet, and then tighten the bolts on both sides by hand to prevent the support from moving;
5: Open the cover, press the button on the front of the cover, remove the cover vertically, reinforce the screws with a Phillips screwdriver, and make it fully tightened;
6: Put the stainless steel decorative cover on the support.
7: Reinstall the cover plate again, check whether the slow-down function of the cover plate is normal, and the installation is complete.
There are many domestic toilet manufacturers with different strengths, and the sizes of toilets produced are also different. When you change the toilet lid, you must first measure the size of your own toilet (note that it is not the size of the old toilet lid), in case you buy back the toilet. The cover cannot be installed.
